adequate protection of all keying material. Trust must be
assumed in the initial installation of the keys, as well as in
the processing of security information. A key can be
associated either to a network, being usable by both Zigbee
layers and the MAC sublayer, or to a link, acquired through
pre-installation, agreement or transport. Establishment of
link keys is based on a master key which controls link key
correspondence. The initial master key must be obtained
through a secure medium (transport or pre-installation), as
the security of the whole network depends on it. Link and
master keys are only visible to the application layer.
Different services use different variations of the link key to
avoid leaks and security risks.
IPv6 promises to be a key enabler for the future of IoT,
providing end-to-end connectivity with a distributed routing
mechanism as well as a highly scalable address scheme,
providing more than 2 billion addresses per square
millimetre of the Earth surface247. This seems sufficient to
address the needs of any present and future communicating
device. Moreover, IPv6 is supported by a large community
of users and researchers supporting ongoing improvement
of its security features.
RFC 4919 describes the requirements for LoWPANs to work
with IPv6, and RFC 4944248 defines the frame format for
transmission of IPv6 packets over IEEE 802.15.4 networks.
Since IPv6 requires support of packet sizes much larger
than the largest IEEE 802.15.4 frame size, an adaptation
layer (“6LoWPAN”) is defined. This RFC also defines
mechanisms for header compression required to make IPv6
practical on IEEE 802.15.4 networks, and the provisions
required for packet delivery in IEEE 802.15.4 meshes.
74
247 https://iot6.eu/ipv6_for_iot
248 https://tools.ietf.org/html/rfc4944
249 Routing Attacks and Countermeasures in the RPL-Based Internet of Things,
Wallgren et al, 2012
250 https://lora-alliance.org/about-lorawan
The Routing Protocol for Low-Power and Lossy Networks
(RPL) is a routing protocol standardised for constrained IoT
environments such as 6LoWPAN networks. Providing
security in IPv6/RPL connected 6LoWPANs is challenging
because the devices are connected to the untrusted
Internet and are resource constrained while using novel IoT
technologies and lossy communication links. If a node
becomes an internal adversary, it can break network
operation without being detected by cryptography
mechanisms. Therefore, analysing RPL threats in addition
to specifying its operation will help to monitor most of the
internal malicious behaviours. RPL in authenticated
security mode uses secure messages. Pre-installed keys
are used to join a network as a leaf to provide message
confidentiality, integrity, and authenticity. To join the
network as a router, a second key must be obtained from a
key authority.249
As opposed to WPANs which are short-range personal-area
networks, low-power wireless wide area networks (LPWANs)
enable long-range, low-power communication at low cost
using simplified, lightweight protocols and either licensefree or licensed bands. LoRaWAN250 is an LPWAN protocol
designed to wirelessly connect battery-operated devices to
the internet. The LoRaWAN network architecture is
deployed in a star-of-stars topology in which gateways relay
messages between end-devices and a central network
server. The gateways are connected to the network server
via standard IP connections and act as a transparent
bridge, simply converting RF packets to IP packets and vice
versa. The wireless communication takes advantage of the
long-range characteristics of the LoRa physical layer,
allowing a single-hop link between the end-device and one
or many gateways. The LoRaWAN specification defines two
layers of cryptography:
Select target paragraph3
Connect to a paragraph
Connect to an entity
Disable highlights
Add to table of contents