10.5.8.R.01.
Rationale
Labelling cables with the correct socket number, equipment type, source or destination minimises the likelihood of improperly cross connecting
equipment and can assist in fault finding and configuration management.
10.5.8.C.01.
ControlSystem Classification(s): Confidential, Secret, Top Secret; Compliance: MUST
[CID:2400]
Agencies MUST label cables at each end, with sufficient information to enable the physical identification and inspection of the cable.
10.5.8.C.02.
ControlSystem Classification(s): All Classifications; Compliance: SHOULD
[CID:2401]
Agencies SHOULD label cables at each end, with sufficient information to enable the physical identification and inspection of the cable.
10.5.9.
Cable register
10.5.9.R.01.
Rationale
Cable registers provide a source of information that assessors can view to verify compliance.
10.5.9.C.01.
ControlSystem Classification(s): Confidential, Secret, Top Secret; Compliance: MUST
[CID:2404]
Agencies MUST maintain a register of cables.
10.5.9.C.02.
ControlSystem Classification(s): All Classifications; Compliance: SHOULD
[CID:2405]
Agencies SHOULD maintain a register of cables.
10.5.10. Cable register contents
10.5.10.R.01. Rationale
Cable registers allow installers and assessors to trace cabling for inspection, tampering or accidental damage. It tracks all cable management
changes through the life of the system.
10.5.10.C.01. ControlSystem Classification(s): Confidential, Secret, Top Secret; Compliance: MUST
[CID:2408]
The cable register MUST record at least the following information:
cable identification number;
classification;
socket number, equipment type, source or destination site/floor plan diagram; and
seal numbers if applicable.
10.5.10.C.02. ControlSystem Classification(s): All Classifications; Compliance: SHOULD
[CID:2409]
The cable register SHOULD record at least the following information:
cable identification number;
classification;
socket number, equipment type, source or destination site/floor plan diagram; and
seal numbers if applicable.
10.5.11. Cable inspections
10.5.11.R.01. Rationale
Regular cable inspections, are a method of checking the cable management system against the cable register as well as detecting tampering,
damage, breakages or other anomalies.
10.5.11.C.01. ControlSystem Classification(s): All Classifications; Compliance: SHOULD
[CID:2412]
Agencies SHOULD inspect cables for inconsistencies with the cable register in accordance with the frequency defined in the SSP.
10.6. Patch Panels, Patch Cables and Racks
Objective
10.6.1. Cable termination, patch panels, patch cables and racks are designed to prevent emanations, cross-connecting or cross-patching systems of differing
classifications as well as following good engineering practice.
Context
Scope
10.6.2. This section covers information relating to the configuration and installation of patch panels, patch cables and fly leads associated with
communications systems.
10.6.3. Reference should also be made to:
Section 8.5 – Tamper-evident seals;
Section 10.1 – Cable management fundamentals;
Section 10.7 – Emanation Security Threat Assessments.
Applicability of controls within this section
10.6.4. The controls within this section are applicable to all communications infrastructure located within facilities in New Zealand. For deployable platforms or
facilities outside New Zealand the Emanation Security Threat Assessments (Section 10.7) of this chapter of this manual MUST be consulted.
Exception for patch cable and fly lead connectors
106
Version_3.5__January-2022
Select target paragraph3
Connect to a paragraph
Connect to an entity
Disable highlights
Add to table of contents