will ensure that data from the destination system cannot be accidently transferred, or maliciously exfiltrated, onto the media used for the data transfer and then onto another system, such as the original source system. Alternatively, if suitable write-once media is not used, the destination system should have a mechanism through which read-only access can be ensured, such as via a read-only device or hardware write-blocker. However, the use of read-only mechanisms is not immune to failure or compromise, therefore, rewritable media should still be sanitised following each data transfer. It is important to note that for most non-volatile flash memory media, it will be possible to sanitise and reclassify it following a data transfer in order to allow it to be connected to other systems again. This is not possible for SECRET and TOP SECRET non-volatile flash memory media as it cannot be reclassified following sanitisation. Security Control: ISM-0347; Revision: 5; Updated: Apr-21; Applicability: All; Essential Eight: N/A When transferring data manually between two systems belonging to different security domains, write-once media is used unless the destination system has a mechanism through which read-only access can be ensured. Security Control: ISM-0947; Revision: 6; Updated: Apr-21; Applicability: All; Essential Eight: N/A When transferring data manually between two systems belonging to different security domains, rewritable media is sanitised after each data transfer. Further information Further information on the protection of media can be found in the Attorney-General’s Department’s Protective Security Policy Framework, Physical security for entity resources policy. Further information on securing media when not in use can be found in the ICT equipment and media section of the Guidelines for Physical Security. Further information on encrypting media can be found in the cryptographic fundamentals section of the Guidelines for Cryptography. Further information on using media to transfer data between systems can be found in the data transfers section of the Guidelines for Data Transfers. Media sanitisation Hybrid hard drives When sanitising hybrid hard drives, separate the non-volatile magnetic media from the circuit board containing nonvolatile flash memory media and sanitise each separately. Solid state drives When sanitising solid state drives, the method for sanitising non-volatile flash memory media applies. Media sanitisation processes and procedures Using approved methods to sanitise media provides a level of assurance that, to the extent possible, no data will be left following sanitisation. The methods described in these guidelines are designed not only to prevent common data recovery practices but also to protect from those that could emerge in the future. Security Control: ISM-0348; Revision: 4; Updated: Dec-21; Applicability: All; Essential Eight: N/A Media sanitisation processes, and supporting media sanitisation procedures, are developed and implemented. 68

Select target paragraph3

Connect to a paragraph
Connect to an entity
Disable highlights
Add to table of contents