13.2.5. Relevant PSR requirements can be found at:
Reference
Title
Source
PSR Mandatory
GOV3, INFOSEC1, INFOSEC2, INFOSEC3,
http://www.protectivesecurity.govt.nz
Requirements
INFOSEC4, PHYSEC1 and PHYSEC2
https://www.protectivesecurity.govt.nz/governance/mandatory-requirements-2/
https://www.protectivesecurity.govt.nz/information-security/mandatory-requirements2/
https://www.protectivesecurity.govt.nz/physical-security/physical-security-mandatoryrequirements-2/
PSR content
Management protocol for information
https://www.protectivesecurity.govt.nz/information-security/management-protocol/
protocols
security
https://www.protectivesecurity.govt.nz/physical-security/management-protocol/
Management protocol for physical security
PSR
Handling requirements for protectively
https://www.protectivesecurity.govt.nz/information-security/classification-system-
requirements
sections
marked information and equipment
Retire information and assets securely
and-handling-requirements/handling-requirements/
https://www.protectivesecurity.govt.nz/physical-security/understand-the-physicalsecurity-lifecycle/retire-information-and-assets-securely/
Managing
Secure your ICT facilities
https://www.protectivesecurity.govt.nz/physical-security/specific-scenarios/physical-
specific scenarios
Physical Security for ICT systems
security-for-ict/secure-your-ict-facilities/
https://www.protectivesecurity.govt.nz/physical-security/specific-scenarios/physicalsecurity-for-ict/
Rationale & Controls
13.2.6.
Reclassification and declassification procedures
13.2.6.R.01.
Rationale
When reclassifying or declassifying media the process is based on an assessment of risk, including:
the classification of the media and associated handling instructions;
the effectiveness of any sanitisation or destruction procedure used;
the planned redeployment; and
the intended destination of the media.
13.2.6.C.01.
ControlSystem Classification(s): All Classifications; Compliance: MUST
[CID:3896]
Agencies MUST document procedures for the reclassification and declassification of media.
13.2.7.
Classifying media storing information
13.2.7.R.01.
Rationale
Media that is not classified or not correctly classified may be stored, identified and handled inappropriately.
13.2.7.R.02.
Rationale
Incorrect or no classification may result in access by a person or persons without the appropriate security clearance.
13.2.7.C.01.
ControlSystem Classification(s): All Classifications; Compliance: MUST
[CID:3904]
Agencies MUST classify media to the highest classification of data stored on the media.
13.2.8.
Classifying media connected to systems of higher classifications
13.2.8.R.01.
Rationale
Unless connected through a data diode or similar infrastructure, there is no guarantee that classified information was not copied to the media
while it was connected to a system of higher classification than the classification level of the media itself.
13.2.8.C.01.
ControlSystem Classification(s): All Classifications; Compliance: MUST
[CID:3910]
Agencies MUST classify any media connected to a system of a higher classification at the higher system classification until confirmed not to be
the case.
13.2.9.
Classifying media below that of the system
13.2.9.R.01.
Rationale
When sufficient assurance exists that information cannot be written to media that is used with a system, then the media can be treated in
accordance with the handling instructions of the classification of the information it stores rather than the classification of the system it is
connected to or used with.
13.2.9.C.01.
ControlSystem Classification(s): All Classifications; Compliance: MUST
[CID:3915]
Agencies intending to classify media below the classification of the system to which it is connected to MUST ensure that:
the media is read-only;
the media is inserted into a read-only device; or
the system has a mechanism through which read-only access can be assured such as approved data diodes, write-blockers or similar
infrastructure.
13.2.10. Reclassifying media to a lower classification
170
Version_3.5__January-2022
Select target paragraph3
Connect to a paragraph
Connect to an entity
Disable highlights
Add to table of contents