applicable requirements for use and shall ensure that the radio equipment is accompanied by
the documents and information referred to in paragraphs 1-4 and in Article 154 paragraph 1a.
7. The importer shall place its name, registered trade name or registered trade mark, if
available, on the radio equipment and a postal contact address. If it is not possible to place this
data on a radio device, in particular because of its size or the need to open the packaging to
indicate the importer's information, the importer shall place it on the packaging or in the
document attached to the device. This data should be given in Polish.
8. Before making the radio equipment available on the market, the distributor shall verify that
the manufacturer has complied with the requirements referred to in paragraphs 1-5 and Article
154 paragraph 1a, and the importer with the requirements referred to in paragraph 7.
Article 158a.ii 1. The manufacturer, before placing the radio equipment on the market, shall
register the types of radio equipment in the central system made available by the European
Commission and place on the radio equipment a registration number issued by the European
Commission.
2. The Minister competent for digitalization may, by means of an ordinance, specify:
1) radio equipment subject to the registration requirement referred to in paragraph 1,
2) technical documentation included in the registration,
3) method of registration,
4) method of placing a registration number issued by the European Commission on the radio
equipment
– having regard to the delegated acts of the European Commission, as referred to in Article 5
(2) of Directive 2014/53/EU of the European Parliament and of the Council of 16 April 2014
on the harmonisation of the laws of the Member States relating to the making available on the
market of radio equipment and repealing Directive 1999/5/EC and having regard to the need
to improve the efficiency and effectiveness of market surveillance and to ensure a high level of
compliance of radio equipment with the requirements.
Article 158b. 1. Before placing radio equipment on the market or putting it into service, the
manufacturer shall affix the CE marking to the equipment after issuing the declaration of
conformity.
2. The CE marking shall be followed by the identification number of the notified body if the
procedure is applied to assess the conformity of radio equipment with the requirements of the
quality assurance system referred to in the executive provisions pursuant to Article 12 of the
Act of 13 April 2016 on conformity assessment and market surveillance systems. The
identification number of the notified body must be the same as the CE marking and shall be
affixed by the notified body or the manufacturer pursuant to guidelines of the notified body.
Art. 158c. 1. The technical documentation shall be drawn up before placing the radio
equipment on the market or putting it into service and shall be systematically updated.
2. Where the technical documentation does not contain sufficient information to support the
compliance of the radio equipment with the requirements, the President of UKE may call the
manufacturer or importer to carry out the examination by a notified body authorised to assess
radio equipment at the expense of the manufacturer or importer and to present, within
a specified time limit, technical documentation that confirms the compliance of the radio
equipment with the requirements referred to in Article 153 paragraphs 1-1b.
Select target paragraph3
Connect to a paragraph
Connect to an entity
Disable highlights
Add to table of contents