Volatile media sanitisation
When sanitising volatile media, the specified time to wait following the removal of power is based on applying a safety
factor to the time recommended by research into preventing the recovery of data. If read back cannot be achieved
following the overwriting of volatile media, or data persists, it will need to be destroyed.
Security Control: ISM-0351; Revision: 6; Updated: Dec-21; Applicability: All; Essential Eight: N/A
Volatile media is sanitised by removing its power for at least 10 minutes.
Security Control: ISM-0352; Revision: 4; Updated: Dec-21; Applicability: S, TS; Essential Eight: N/A
SECRET and TOP SECRET volatile media is sanitised by overwriting it at least once in its entirety with a random pattern
followed by a read back for verification.
Treatment of volatile media following sanitisation
Research suggests that short-term remanence effects are likely in volatile media. For example, up to minutes at normal
room temperatures and up to hours in extremely cold temperatures. Furthermore, some volatile media can suffer from
long-term remanence effects resulting from physical changes due to the continuous storage of static data for extended
periods of time. It is for these reasons that under certain circumstances TOP SECRET volatile media retains its
classification following sanitisation.
Typical circumstances preventing the reclassification of TOP SECRET volatile media include a static cryptographic key
being stored in the same memory location during every boot of a device, or a static image being displayed on a device
and stored in volatile media for a period of months.
Security Control: ISM-0835; Revision: 4; Updated: Dec-21; Applicability: TS; Essential Eight: N/A
Following sanitisation, TOP SECRET volatile media retains its classification if it stored static data for an extended period
of time, or had data repeatedly stored on or written to the same memory location for an extended period of time.
Non-volatile magnetic media sanitisation
Non-volatile magnetic media encompasses non-volatile magnetic hard drives, tape drives and floppy disks. While nonvolatile magnetic tape drives and floppy disks can be sanitised by overwriting them at least once (or three times if pre2001 or under 15 GB) in their entirety with a random pattern followed by a read back for verification, additional
considerations apply to non-volatile magnetic hard drives due to their use of a host-protected area, device
configuration overlay table and growth defects table.
Both the host-protected area and device configuration overlay table of non-volatile magnetic hard drives are normally
not visible to a computer’s Unified Extensible Firmware Interface or operating system. Therefore, any sanitisation of the
readable sectors of non-volatile magnetic hard drives will leave any data contained in sectors listed in the hostprotected area and device configuration overlay table untouched. Some sanitisation programs include the ability to
reset non-volatile magnetic hard drives to their default state, thereby removing any host-protected areas or device
configuration overlays. This allows the sanitisation program to see the entire contents of non-volatile magnetic hard
drives during subsequent sanitisation processes.
Modern non-volatile magnetic hard drives automatically reallocate space for bad sectors at a hardware level. These bad
sectors are maintained in what is known as the growth defects table or ‘g-list’. If data was stored in a sector that was
subsequently added to the growth defects table, sanitising the non-volatile magnetic hard drive will not overwrite such
data. While these sectors may be considered bad by non-volatile magnetic hard drives, quite often this is due to the
sectors no longer meeting expected performance norms and not due to an inability to read or write to them. The
Advanced Technology Attachment (ATA) secure erase command was built into the firmware of post-2001 non-volatile
magnetic hard drives and is able to access sectors that have been added to the growth defects table.
Modern non-volatile magnetic hard drives also contain a primary defects table or ‘p-list’. The primary defects table
contains a list of bad sectors found during post-production processes. No data is ever stored in sectors listed in the
69
Select target paragraph3
Connect to a paragraph
Connect to an entity
Disable highlights
Add to table of contents